It also bears mentioning that drywall sanding dust is a respiratory irritant.
If you stand it on edge and it falls over, someone--especially a child--could get hurt. Tighten the screw usually a quarter-turn is sufficient or tap in the nail.
It's best to do a repair with three or four thin coats of compound--if possible leaving sanding for just the last coat. Score down the line centered on the stud. Watch The Weight. The key is to leave a wide and very shallow slope on all sides, he says.
It's also easy to repair badly, which can leave a lumpy mess that declares "shoddy" to anyone who enters the room.
Beware Of Buckets. If you have an entire house to repair, buy a 4. They both are easy to work with, and have a shelf life at room temperature of about nine months. Sand it smooth and apply a second coat if necessary.
To repair a large hole, first draw a square around it. Wear a dust mask when sanding to block airborne gypsum and silica particles. Advertisement - Continue Reading Below. Compound Interest.
The differences between the two are that the lightweight product weighs about a third less than all-purpose, it dries more quickly and takes less force to sand.
Smooth the dried compound with a hand sander fitted with coarse sanding mesh.
Cut out a piece of damaged drywall tape in an inside corner, then apply a bed of drywall compound. Be advised that it's more difficult to work with in some of the repairs we show. Use a level to center one side of the square on a nearby stud.
Before the drywall compound dries, add texture to it with a short-handled stomping brush. Some adhesive should squeeze from the joint to indicate a secure bond. Level the repair with the surrounding surface.